Preview

Ecology and Industry of Russia

Advanced search
Open Access Open Access  Restricted Access Subscription or Fee Access

Investigation of Dusting Process in Centrifugal-Inertia Devices

https://doi.org/10.18412/1816-0395-2013-11-8-11

Abstract

There were carrying-out trials of experimental dust arrester on real dust air mixture of unit for treatment of galvanic sludges into iron-oxide pigment. There was determined that in centrifugal-inertia separator the dust separation process takes place in three different working zones: swirl zone of gas-dust stream; zone of dust concentrating and solid phase’s layer formation on the body wall centrifugally; zone of particles deflection from separating zone owing to retardation of more inertial particles of finely-divided particulates or condensed phase form gas under gas stream rotation. On the base of experimental data was developed simulation model of separation process of finely-divided dust in centrifugal-inertia dust arrester and programming and computing suite for calculation of main process-dependent and design parameters of one-stage of two-stage dust arresters. Owing to decreasing of secondary dust loss in centrifugal-inertia dust arrester, was able more than 1,5 – 2 time increase separation of air-dust mixtures in common cyclone, and purification rate depending of dispersive capacity  and density of separate dust is from 75 to 98 per cents for different finely-divided aerosols of solid condensed phase.

About the Authors

Ya. V. Chistyakov
Московский государственный университет путей сообщения, ярославский филиал
Russian Federation


A. A. Makhnin
Ярославский государственный технический университет
Russian Federation


N. L. Gurylyova
Ярославский государственный технический университет
Russian Federation


N. I. Volodin
Ярославский государственный технический университет
Russian Federation


References

1. Вальдберг А.Ю, Кирсанова Н.С. К расчету эффективности циклонных пылеуловителей // ТОХТ. 1989. Т. XXIII № 4.

2. Зверев Н.И., Ушаков С.Г. Физическое и математическое моделирование процесса центробежной сепарации пыли // Инженерно-физический журнал. 1980. № 3.

3. Справочник по пыле- и золоулавливанию / Под ред. М.И. Биргера, А.Ю. Вальдберга, Б.И. Мягкова и др.; под общей ред. А.А. Русанова. 2-ое изд. М.: Энергоатомиздат, 1983.

4. Чистяков Я.В., Качурин Н.М., Махнин А.А., Володин Н.И. Разработка пылеуловителей нового поколения // Экология и промышленность России. 2013. Май.

5. Чистяков Я.В. Исследование и разработка пылеуловителей, обеспечивающих повышение эффективности очистки воздуха аспирационных систем дробильно-сортировочных комплексов карьеров. Дис. ... канд. техн. наук. Тула, 2012.

6. Чистяков Я.В., Махнин А.А., Невский А.В. Математическая модель для определения параметров центробежно-инерцонного пылеуловителя // Известия высших учебных заведений. Химия и химическая технология. Иваново. 2012. Т. 55. Вып. 12


Review

For citations:


Chistyakov Ya.V., Makhnin A.A., Gurylyova N.L., Volodin N.I. Investigation of Dusting Process in Centrifugal-Inertia Devices. Ecology and Industry of Russia. 2013;(11):8-11. (In Russ.) https://doi.org/10.18412/1816-0395-2013-11-8-11

Views: 459


ISSN 1816-0395 (Print)
ISSN 2413-6042 (Online)